Survey

Maximizing the Controller Display and Touchscreen Lifespan

Maximizing the Controller Display and Touchscreen Lifespan Controller displays and touchscreens require proper care to prolong life. To maximize the lifespan of the controller touchscreen, a screen protector must be applied to the touchscreen at all times. A screen protector will protect the controller touchscreen from scratches, dust, condensation, and stylus wear. Trimble recommends that [...]

By |2017-11-07T23:47:25-06:00November 9th, 2011|Survey|0 Comments

Post Processing Problems in Trimble Geomatics Office

Dear Trimble Survey customers, On September 14, 2011, it was discovered that the WAVE baseline processor in Trimble Geomatics Office (TGO) and GPSurvey could not process GPS observations collected on or after that date. The failure in the WAVE processor was not anticipated due to the fact that both products had been discontinued (TGO was [...]

By |2017-11-07T23:47:25-06:00September 23rd, 2011|Survey|0 Comments

NGS releases revised coordinates for all CORS sites…

On September 6, 2011 NGS's CORS group released revised coordinates for all CORS sites. The new coordinates update both the global frame and the National Spatial Reference Frame as follows. New Frames Previous Frames IGS08 Epoch 2005.00 ITRF00 Epoch 1997.00 NAD 83(2011) Epoch 2010.00 NAD 83(CORS96) Epoch 2002.00 NAD 83(MA11) Epoch 2010.00 NAD 83(MARP00) Epoch [...]

By |2017-11-07T23:47:25-06:00September 7th, 2011|Survey|0 Comments

Confused by the lights on the top of your TSC3?

Unwilling to read the manual?  What manual?  Where is it? Here is what the lights do and mean.... Notification LEDs At the top of the unit are three LEDs that provide status information: Left LED Center LED Right LED Colors: amber, green, red Colors: amber, green, red Colors: amber, blue, green Battery Status: Green: fully [...]

By |2017-11-07T23:47:26-06:00May 3rd, 2011|Survey|0 Comments

Clean Booting a TSC3

  Perform a Clean Boot...This is like a hard reset. WARNING: Application software installed by the customer and some licenses, settings and user data will be cleared if this function is performed! Hold down the Power key until the countdown begins and then release it to show the Power Menu described above. Tap Reset. Upon [...]

By |2017-11-07T23:47:26-06:00May 2nd, 2011|Survey|2 Comments
Go to Top